At Chardon Laboratories, providing commercial cooling tower services is one of our specialties. One of the common questions that we receive is: “how much water should there be in my cooling tower?” In this post, we’ll review the meaning of “low flow”, as well as provide insight into ways that you ensure there is adequate water within your cooling tower.
What is “low flow” in a cooling tower?
A cooling tower is designed to remove heat by evaporation of water. The tower is also designed to have a minimum and maximum amount of water flow over (or through) the tower’s “fill”. The fill in the tower is designed to increase the surface area of the water that can be exposed to air. The larger the surface area of the water passing through the fill, the more efficient and faster the heat transfer to the atmosphere. When the amount of water passing through the tower fill is less than the designed minimum amount, it is considered “low flow”.
What Is The Problem With Low Water Levels?
During normal operation of a cooling tower, the required evaporation will increase the concentration of the dissolved solids. Therefore, the hot water at the top of the tower will increase in dissolved solids during the evaporation process until it hits the bulk water in the sump of the tower. When the normal amount of water is passing through the fill, the resulting concentration of dissolved solids in the sump is usually negligible during a single pass. However, when less than the minimum amount of water is passing through the fill, the evaporation process will still remove the same amount of water from that low flow. The concentration of the dissolved solids in the low flow water will increase much faster. It may increase so rapidly that the current chemicals in the water may not be able to keep the dissolved solids dissolved any longer and some precipitation may occur!
How do I know when a “low flow” situation exists?
By inspection of the tower, normally the “hot decks” (or distribution pans) are supposed to be filled to about one inch from the top of the pan. If you observe that the water level in the hot deck is much less than one inch from the top of the pan, then you may have the problems mentioned above. Typical towers usually have about 4 to 6 inches of water depth in the hot deck. If the fan on the tower is running and you have low flow, then the problem of over concentration of dissolved solids is going to be more severe.
How Do I Fix Low Water Levels in My Cooling Tower?
You should verify from the tower manufacturer the amount of designed water flow for that individual tower. The tower manufacturer may need to know the orifice number to determine the normal water depth in the hot deck. If the water in the hot deck does not approach the estimate of the tower manufacturer, then notify the person responsible for the facility of your findings. Some possible solutions are: open the balancing valves further, clean pump strainers, check valves that limit flow to the tower, clean rust chips from the balancing valves, etc.
Get a Professional Opinion with Chardon Labs
If you would like our team of experts to check your cooling tower and provide a professional opinion regarding adequate water levels, contact us online today or give us a call at 888-660-1724. Our team is always happy to answer questions and provide more information.